Nsc6001 | Acpi

unsigned long flags; u8 reg; spin_lock_irqsave(&nsc_gpio_lock, flags); reg = inb(nsc_gpio_base + 1); if (value) reg : This driver cannot access the advanced features (interrupts, debounce, alternate functions) because ACPI NSC6001 does not expose those register offsets in a standard way. For full Geode GPIO, the gpio-cs5535 driver is preferred. 5. ACPI vs. Legacy Probing Conflict A key technical challenge is that the Geode CS5536 also provides PCI configuration space for GPIO (Vendor ID 0x1022 National Semiconductor/AMD). If both the ACPI NSC6001 device and the PCI CS5536 driver bind to the same hardware, resource contention occurs.

The actual hardware uses a memory-mapped I/O (MMIO) or port I/O scheme. In typical Geode LX designs, the GPIO is memory-mapped at 0xF0000000 + offset or via PCI config space of the CS5536. The NSC6001 can generate interrupts on GPIO pin state changes. However, the interrupt lines are routed through the Geode’s PIC (8259-compatible) or IOAPIC via a chained interrupt. Linux drivers must parse the ACPI _CRS to find the IRQ resource. 3. ACPI Implementation for NSC6001 3.1. ACPI Device Object In the system’s DSDT (Differentiated System Description Table), the NSC6001 appears as: acpi nsc6001

Note: Documentation varies; the Linux nsc_gpio driver actually uses a simpler 2-register model: OUT and IN at offsets 0 and 1 (byte-wide). This discrepancy suggests two different revisions or the driver abstracts only a subset. ACPI vs

Example (simplified):

| Offset | Register | Purpose | |--------|---------------|-------------------------------------------------------------------------| | 0x00 | OUT_SELECT | 0 = output, 1 = input (direction). Actually, the Geode uses "OUT_EN". | | 0x04 | OUT_AUX_SELECT| Alternate function selection. | | 0x08 | OUT_DATA | Output data register (set/clear output bits). | | 0x0C | IN_DATA | Input data register (read pin states). | | 0x10 | IN_STATUS | Edge detection status. | | 0x14 | IN_AUX_SELECT | Debounce / IRQ configuration. | The actual hardware uses a memory-mapped I/O (MMIO)

Device (GPIO) Name (_HID, "NSC6001") // Hardware ID Name (_CID, "NSC6001") // Compatible ID Name (_CRS, ResourceTemplate () IO (Decode16, 0x6100, 0x6100, 0x01, 0x10) // I/O port range IRQ (Edge, ActiveHigh, Shared) 11 // IRQ line ) Name (_DSD, Package () ... ) // Device-Specific Data (optional)

Abstract The ACPI NSC6001 Hardware ID identifies the GPIO (General Purpose Input/Output) controller found on the AMD Geode LX series of system-on-chip (SoC) devices. While this hardware is largely obsolete, its implementation within the Linux kernel (specifically drivers/gpio/gpio-nsc768.c and the legacy nsc_gpio driver) provides a rich case study in the transition from legacy x86 embedded I/O to ACPI-enumerated device drivers. This paper dissects the hardware architecture, the Linux driver model complexities, and the specific role of ACPI in bridging a non-PnP legacy device into a modern OS framework. 1. Introduction The Advanced Configuration and Power Interface (ACPI) is the standard for device enumeration, power management, and configuration in x86-based systems. While modern systems are dominated by PCIe and ACPI-defined standard devices (e.g., PNP0C09 for EC), legacy embedded controllers often hide behind proprietary or semi-standard Hardware IDs (HIDs).